User`s guide

2-10
2 Maintenance
Perfect binder User’s Guide 05
<Z00-000>Check Settings Errors
This error message is displayed when a cover is not completely closed.
<W000-000> Warning
These warning messages are displayed when there is no more paper, the output tray is full, a peripheral device is
not connected, or there is another problem.
Message Action to Take
Close the front cover (side cover, cover
sheet inserter)
of the perfect binder.
The Perfect binder's front cover (side cover, cover sheet
inserter) is not completely closed.
Securely close it.
Message Action to Take
Job name:
This printing job is not acceptable
because perfect binder is
unavailable. Printing without using
the perfect binder is possible.
(The job has been deleted).
Turn off the power of the Perfect binder and then on again.
There is a sequence to turn on the power of the Perfect binder.
See "Turning the Power ON/OFF" (p. 23) for details on turning
the power on.
If the recovery operations above does not help solve your error,
contact your dealer (or authorized service representative).
Press [Close] to continue using the printing functions other than
for binding.
Set paper with a size suitable for
the cover of the perfect binding in
the tray below.
Selected tray:
size:
There is no paper in the tray for cover sheets or the different
size paper is loaded. Load the right kind of paper in the
specified tray.
This cover paper is not allowed for
perfect binding. Load the appropriate
size of paper in the following tray.
Selected tray:
Size:
Set paper for the cover of the
perfect binding in the tray below.
Selected tray:
Size:
There is no paper in the tray for cover sheets. Load paper for
the cover in the spacified tray.
Binding is not possible because
the length of the body and
cover of perfect binding is not
consistent.
Check the settings.
(The job has been deleted.)
The size combination of the cover and body pages is not
correct. Different size paper from the original size is loaded in
the feed tray. Load cover paper of the same size as that of the
body pages.
Binding is not possible because
the perfect binder has detected
an error in the thickness of the
body. Check the settings.
(The job has been deleted.)
In original data, the amount of body pages is too low so that the
spine width is too thin; or the body is too thick to bind with the
cover. Check the data.
For details on the available width, see "Specifications" (p. 3-2).
Set paper for the body of the perfect
binding in the tray below.
Selected tray:
Size:
There is no paper in the tray for body pages or the different size
paper is loaded. Load the right kind of paper in the specified
tray.