Hardware Guide
CT 4000 - OVERVIEW AND HARDWARE GUIDE
© ORBCOMM
®
Proprietary
W01-ECert, Version 1.1
7
2.3 Other Certification
International
certification
Compliant with UN 38.3 – International/EU certification for battery cell/pack transportation.
Industrial Certificate:
PTCRB
REACH
Registration, Evaluation, Authorization, Restriction of Chemicals
Ingress Protection: IP67
2.4 Environmental
Parameter
Description
Altitude
The device meets all of its specifications after a nonoperating 12,000 ft. altitude test at -40°C
Salt Spray Atmosphere
The device meets all of its specifications after a salt spray test as detailed in ASTM 117B.
Exposure to Chemicals
and Oils
The device meets all of its specifications after a light to moderate splash test as detailed in SAE
J1455 section 4.4.3.2, for the following chemicals:
HCl, strong;
Dilute acids (Sulfuric);
Dilute bases
(Sodium Hydroxide); Moderately strong acids (sulfuric & phosphoric 5 and 20%);
Spray lubricates LPS/
WD40/CRC, etc.;
Ethylene Glycol;
POE Oil; Mineral Oil;
Diesel Exhaust; Diesel Engine Oil; Engine Oils
and Additives;
Refrigerant / Oil mixes with 5% H20;
Transmission Oil;
Rear Axle Oil;
Power Steering
Fluid; Brake Fluid;
Axle Grease; Window Washer Solvent;
Gasoline; Diesel Fuel; Fuel Additives;
Alcohol;
Antifreeze Water Mixture;
Degreasers; Soap and Detergents;
Steam
; Waxes;
Kerosene;
Freon;
Spray Paint;
Paint Strippers;
Ether;
Dust Control Agents (magnesium chloride); Moisture
Control Agents (calcium chloride); Ammonia; Aluminum brightener (acid wash)
Vibration
The device meets ± 1.8 G testing for 2.1 million cycles in vertical direction, ± 1.4 G testing for 2.1
million cycles in the fore/aft, and side to side directions, 5-100 Hz (excursion not exceeding 1”
peak to peak) in any direction.
Humidity
The device meets all its specifications during exposure to 90% relative humidity at +85°C, per the
t
e
s
t
m
e
t
h
o
d
o
l
o
g
y
o
f
S
A
E
J
1455
,
s
e
c
t
i
o
n
4
.
2
.
3
(
8
h
o
u
r
hu
m
idi
t
y
c
y
c
le
p
e
r
f
i
g
u
r
e
4
a
)
.
Steam Cleaning and
Pressure Washing
The device meets all of its specifications after a steam cleaning and pressure wash test as
de
t
a
iled
in
S
A
E
J
1455
,
s
e
c
t
i
o
n
4
.
5
.
3
.
Mechanical Shock
Non-operational: The device meets all its specifications after five (5) consecutive impact events of
100 G for 18-25ms, half sine pulse in three mounting planes of the assembly.
Operational: The device meets all its specifications after five (5) consecutive impact events of 15
G for 18-25ms, half sine pulse in three mounting planes of the assembly.
Dust and Sand
Bombardment
The device meets all of its specifications after a dust and sand bombardment test as detailed in
S
A
E
J
1455
,
s
e
c
t
i
o
n
4
.
7
.
3
.