User Guide

Tutorial 2 - Modifying
Version 5.0 63
mouse cursor passes over them. Back in the model view our cursor is still
which indicates that we are still in drawing mode.
Move the pencil tip from the bottom of the front left column up the length of the
column. When the tip of your cursor reaches the quarter point of the member a
red dot will appear indicating the presence of a graphical editing point. When this
point appears, the status bar will display the coordinate location of the drawing
point. This should be listed as 21, 4.625, 30 as highlighted in the figure below:
Click on this drawing point (21, 4.625, 30). Then do the same for the middle
column (21, 4.625, 15) and the right column (21, 4.625, 0). When you are
finished your screen should look like the following:
Status Bar
Coordinate Display
Graphical
Editing Point