User Guide

Tutorial 2 - Modifying
Version 5.0 59
Click Apply.
Our entire frame was “selected” so all of the frames were be copied. In addition
to copying the joints and members, if we had any loads on the frames they would
have been copied as well. Your structure should look like the following image:
We will now add the connecting beams.
First click to maximize the view plane. Then click the Draw / Modify
Members button on the Drawing Toolbar. Be sure to click on the Draw
Members tab. Then click on Assign Section Set and select “Beam-Z” from the
drop down menu.
The end releases should already be set to Fully Fixed for both ends.
Click Apply and we are ready to draw.