User Guide

Tutorial 1 - Modeling
Version 5.0 23
We will start by drawing a line from point A to point B as shown here:
Move the mouse to the lower left corner of the grid (point A, location 0,0,0) and
click once.
You should now have a line drawn from that point to the mouse, this line follows
the mouse as you move it. Also a joint has been created and labeled N1. If you
don’t see this, it means you weren’t very close to the lower left grid point when
you clicked, so try again.
Now move straight up to point B, grid location (0,18.5,0) and click again.