Risco Group Modular Certification Instructions to OEM P/N Number: RWTRSS10433B-40 FCC ID: JE4STAMP433 1. Revision History Revision 3 April 2014 1 June 2014 Revision Description of Changes Initial Release Modification Page 1 of 5 © 2014 by Risco Group Ltd. All rights reserved.
. Introduction This document describes mandatory steps required by the OEM Integrator when assembling the Stamp to the unit. This document lists the mandatory responsibilities and actions of the OEM integrator. Failure to comply with all requirements and conditions in this document may result in non compliance of the device with FCC rules and invalidate the RISCO Group FCC certification for the Stamp. 3. Overview The RWTRSS10433B-40 is a "Stamp" transmits in 433.92 MHz.
4. Allowed Antennas to be used Helical HQ P/N: ANT434-CHETH-R Frequency: 433.92 MHz Gain: Max +3dbi Soldered to PCB, resists soldering of 260deg +/-5second Material: Comply with Directive 2002/95/EC Restriction of Hazardous substances, RoHS Directive, HQ, Beryllium Copper, wire diameter 0.9 mm, tolerance +/- 0.07 mm Heat Treating material to procure PIM ≤ -138dBc @ Standard Installation Platting: Tin plating per ASTM–B-545, 5 microns followed by Nickel-plating 5 microns per MILC-26074. RoHS Compliance. 5.
6. FCC statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
7. OEM instructions 1. The module is limited to OEM installation only. 2. The OEM integrator is responsible for that the end-user has no manual instructions to remove or install the module. 3. The module is limited to installation in mobile or fixed applications, according to part 2.1091(b). 4. Separate approval is required for all other operating configurations, including portable configurations with respect to part 2.1093 and different antenna configurations. 5.
