User guide

Flash ROM

8. Then the program prompts you :

Are you sure to program (y/n)

9. You will need to make a selection:

No Yes

If you DO NOT wish to update the

BIOS, type n.

The program exits to the command

line. Skip the following steps in this

section and go directly to the next

section.

If you DO wish to update the BIOS,

type y.

When the updating is finished, the

following message appears:

Programming Flash Memory -

7FFFF OK

::::::::::::::::::::::::::::::::::::::::::::::

Restart your system. Your BIOS

should be successfully updated.

Command Line Parameters

You may run the BIOS flash update utility at the DOS command line. This section

describes the command line parameters and switches, with examples of their

usage.

NOTE:

This document describes parameters implemented in Award flash update utility

version 7.08. For a full list of parameters in the version you are running, type

awdflash /? and press ↵

3-3