User guide

BIOS Setup
BIOS Setup
DMA/master
W hen you are On of DMA / ISA Master, any activity from
one of the list system peripheral devices wakes up the
system.
The choice: OFF (Default), ON
Modem Ring
Resume
An input signal on the Modem/LAN/Ring/KB wakens the
system from a soft off state.
The choice: Disabled, Enabled
RTC Alarm
Function
When Enabled, your can set the date and time at which
the RTC (real-time clock) alarm awakens the system
from Suspend mode. Default is Disabled
Date (of Month) Specify date when the system should
wake up from suspend m ode.
Resume Time
(hh:mm:ss)
Specify time when the system should
wake up from suspend mode. You
can press <TAB> to enter the next
field.
Prim ary INTR
W hen set to On (default), any event occurring at will
awaken a system which has been powered down.
Th e follow ing is a list of IR Qs,
I
nterrupt
R
e
Q
uests, which
can be exempted much as the COM ports and LPT ports
above can. W hen an I/O device wants to gain the
attention of the operating system, it signals this by
causing an IRQ to occur. W hen the operating system is
ready to respond to the request, it interrupts itself and
performs the service.
W hen set On, activity will neither prevent the system
from going into a power management mode nor awaken
it.
IRQ3 (COM 2): Enable (Default)
IRQ4 (COM 1): Enable (Default)
IRQ5 (LPT 2): Enable (Default)
IRQ6 (Floppy Disk): Enable (Default)
IRQ7 (LPT 1): Enable (Default)
IRQ8 (RTC Alarm): Disabled (Default)
IRQ9 (IRQ2 Redir): Disabled (Default)
IRQ10 (Reserved)): Disabled (Default)
IRQ11 (Reserved): Disabled (Default)
IRQ12 ( PS / 2 M ouse ): Enable (Default)
IRQ13 (Coprocessor): Enable
IRQ14 (Hard Disk) : Enable (Default)
IRQ15
(
Reserved
)
:Disabled
(
Default
)
2-27