User guide

Hardware Installation

Overview

Hardware Installation

IMPORTANT

Ribbon cables should always be connected with the red stripe on the Pin 1 side of the

connector. IDE ribbon cable must be less than 46cm (18inches), with the second drive

connector no more than 15cm (6 inches) from the first connector.

1. ATX Power Supply (20-pin ATXPWR)

The connector connects to ATX power supply. Find the proper orientation and

push down firmly to make sure that the pins are aligned. For Wake on LAN support

5-volt Stand-by lead (+5VSB) from ATX power supply must supply at least 720mA.

2. Floppy Disk Drive Connector (34-pin FLOPPY)

This connector supports the provided floppy disk drive ribbon cable. Afte

connecting the single end to the board, connect the plug on the other end to the

floppy drive.

1-11