User guide

Hardware Installation
Overview
Hardware Installation
Note
Should you want to clear the RTC data:
(1) Turn off your computer
(2) Short pin2 and pin3 with jumper for two seconds
(3) Connect pin1 and pin2 with jumper
(4) Turn on your computer
(5) Hold down <Delete> during bootup and enter BIOS setup to re-enter user
preferences.
2. FSB Force to 133 MHz (Jumper CN6)
This jumpers allow the user to force the FSB frequency of the CPU to a specify
value. According to this value, a user can set a range of values in the selection
CPU speed setting in the BIOS utility. (Please also refer to
Page 2-34). This is only for Overclocking purpose
CN6 Description
Close System will detect the FSB frequency of the CPU
automatically. (Default)
Open Force the 100MHz FSB frequency of the CPU to
133MHz
1-3
CN6
Open: FSB force to 133MHz