User guide

Hardware Installation
Overview
Hardware Installation
Step 1.
Jumper Setting
There are two jumpers you can use to change the setting on the motherboard.
Item Connectors Page
1 Clear Real Time Clock (RTC) RAM (CLRTC) 1-2
2 FSB Forces to 100/133 MHz 1-3
1. Clear Real Time Clock (RTC) RAM (CLRTC)
The onboard button cell battery powers the CMOS RAM. It contains all the
BIOS setup information. Normally, it is necessary to keep the jumper
connected to pin1 and pin2 (default) to retain the RTC data as shown below.
1-2
1
1-2: Normal
2-3: Clear
J22