User`s guide

BIOS Setup

BIOS

Setup

phoeniX multiboot

Phoenix MultiBoot expands your boot options by letting you choose your boot device on

startup, which could be a hard disk, ﬂoppy disk, or a CD-ROM. You can conﬁgure your boot

device in Setup, or you can choose a different device each time you boot during POST by

selecting your boot device in The Boot First Menu.

MultiBoot consists of:

* The Setup Boot Menu

* The Boot First Menu

Refer to the Boot Menu in BIOS Setup for more information on the Setup Boot Menu. The

following describes the Boot First Menu.

The Boot First Menu

Display the Boot First Menu by pressing <Esc> during the POST. In response, the BIOS ﬁrst

displays the message, “Entering Boot Menu ...” and then displays the Boot Menu at the end

of POST. Use the menu to select any of these options:

* Override the existing boot sequence (for this boot only) by selecting another

boot device. If the speciﬁed device does not load the operating system, the

BIOS reverts to the boot sequence stored in Setup.

* Enter Setup.

* Press <Esc> to continue with the existing boot sequence

Boot Menu

Select boot device or Setup.

Use the Up and Down arrows to select the Boot

First device, then press <Enter> or <Esc> to exit.

1. Hard Drive

2. ATAPI CD-ROM

3. Diskette Drive

4. Removable Devices

5. Network Boot

<Setup>

If there is more than one bootable hard drive, then the ﬁrst one in the Setup Boot menu is

the one represented here.