User`s guide

Serverboard Manual
48
BIOS
Setup
eXit menu
The Exit menu selection in the menu bar on top of the screen displays the following:
PhoenixBIOS Setup Utility
Main Advanced Security Power Boot Server Exit
Item Specific Help
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Exit System Setup
and save your
changes to CMOS.
F1 Help Select Item –/+ Change Values F9 Setup Defaults
ESC Exit Select Menu Enter Select
»
Submenu F10 Save and Exit
eXit saving Changes
After making your selections on the Setup menus, select “Exit Saving Changes” or “Save
Changes” to see a screen similar to the following:
Setup Confirmation
Save configuration changes and exit now?
[Yes] [No]
* Select Yes and press <Enter> to save the changes.
Both procedures will store the selections displayed in the menus into the CMOS (short for
“battery-backed CMOS RAM”) a special section of memory that stays on after you turn
your system off. The next time you boot your computer, the BIOS configures your system
according to the Setup selections stored in the CMOS.
During boot up, PhoenixBIOS attempts to load the values saved in CMOS. If those values
cause the system boot to fail, reboot and press <F2> to enter Setup. In Setup, you can
restore the Default Values <F9> or try to change the selections that caused the boot to fail.
The following sections describe each of the options on this menu. Note that <Esc> does not
exit this menu. You must select one of the items from the menu or menu bar to exit.
eXit disCarding Changes
Use this option to exit Setup without saving in the CMOS any new selections or changes you
may have made. The selections previously in effect remain in effect.