User`s guide

21
Hardware Install
Hardware
Install
rear panel i/o ports
This is an illustration of the ServerBoard rear I/O port array
PS/2 Mouse Connector (6-pin Female)
The system will direct IRQ12 to the PS/2 mouse if one is detected. If no mouse is detected,
IRQ12 will be free for expansion cards to use.
PS/2 Keyboard Connector (6-pin Female)
This connection is for standard keyboards using a PS/2 (mini DIN) plug. This connector will
not accept standard AT size (large DIN) keyboard plugs. You may need a DIN to mini DIN
adapter for standard AT keyboards.
Universal Serial BUS Ports I & 2 (Two 4-pin Female)
Two onboard external USB 1.1 ports are available for connecting USB devices.
Serial Port (COM1) Connector (9-pin Male)
The COM1 serial port can be used for pointing devices or other serial devices. See BIOS
for more on serial port setup.
VGA Connector (15-pin Female)
The VGA port connects to a display device. See BIOS for more information VGA setup.
Onboard LAN Ports 2 & 1 (RJ-45)
This ServerBoard uses the Broadcom BCM570x Gigabit Ethernet Controller. There are two
RJ-45 ports available for connecting to networks. The controller consists of both the Media
Access Controller (MAC) and Mbps Physical Layer (PHY) interface. Refer to the “Onboard
LAN User Guide” for further information.
PS/2 Mouse
PS/2 KBD
USB
Ports
COM1 VGA
LAN2 LAN1