User guide

9
RF-Polar
™
Place wand contacts on the skin and immediately
move the wand slowly in a small circular motion
in an area the size of your palm.
IMPORTANT: All four wand contacts must be
touching the skin for unit to have effect.
NOTE: As the skin warms up it will redden,
particularly on the Highest Heat Level.
After approximately 1-2 minutes (depending on
the heat level selected) all three CONSOLE lights
should begin to FLASH along with the WAND
light, indicating that you need to move to the next
adjacent area.
NOTE: If skin starts to feel uncomfortably hot
before the lights begin to flash remove the
wand and refer to troubleshooting section.
Continue to work over your entire ‘Treatment Zone’
using this method.
Once entire ‘Treatment Zone’ has been covered, a final
warming is required. Work over the entire area again in
large sweeping circles for approximately 2 minutes.
Treatment is now complete.
7
8
INSTRUCTIONS FOR USE
CAUTION SKIN OVERHEATING:
Indicated by RAPIDLY CIRCULATING
console lights and RAPIDLY FLASHING
wand light. Move to the next adjacent
area immediately.
5
6