Instructions / Assembly


Watch the video: www.rinsekit.com/faq
Turn off valve on RinseKit hose. Slide down blue sleeve to release
quick connect from the nozzle.
Locate a hose bib connected
to your home.
Tightly screw on hose bib
adapter directly to hose bib.
Attach quick connect to hose bib
adapter. You will hear the quick
connect click when it locks in place.
Turn on RinseKit valve.
1
4
2
5
3
6
Turn off hose bib.Turn on hose bib and allow 30


Turn off RinseKit valve.
Pull down blue quick connect
sleeve to disconnect hose
from hose bib adapter.
Turn on valve on RinseKit
hose and spray away!
Insert nozzle into quick connect.
You will hear the quick connect
click when it locks on to the nozzle.
7
10
8
11
9
12

COMES WITH A PUMP
Watch the video: www.rinsekit.com/faq
Your purchase includes: a RinseKit Plus, Pressure Booster
Pump, a spare parts bag with an extra drain plug, two
hose bib adapters, some extra o-rings and a sticker.


HOSE BIB OR SINK:
1. Unscrew the drain plug from your RinseKit and
pour water into the tank.
2. When the RinseKit is 95% full and there is about
one (1) inch of air space at the top, screw the
drain plug back in.
3. When the drain plug is securely installed, use your
hand to pump pressure into the unit. Make sure
to look at the pressure gauge located on the top
of the pump to ensure that you are pressurizing
your RinseKit to the recommended 65psi.
4. If you’d like to reset the PSI gauge, push the small
button on the side of the pump.
Built in gauge ensures
proper pressure (65psi)