Installation manual

Rinnai Australia 3 Operation & Installation Manual
SAFETY
• Failure to comply with these instructions could result in a fire or explosion, which
could cause serious injury, death or property damage.
• Improper installation, adjustments, service or maintenance can cause serious
injury, death or property damage. Such work must be performed by an authorised
person.
• The appliance must be installed in accordance with the local gas and electrical
authority regulations.
• Flue terminal must always vent directly to outdoors.
• DO NOT extend the flue vertically or horizontally in ways other than prescribed in
the appliance manufacturers’s installation instructions.
• For information on gas consumption, see data plate on the appliance.
• This appliance must not be installed where curtains or other combustible materials
could come into contact with it. In some cases curtains may need restraining.
• WARNING: This heater must not be used if the glass panel is damaged.
• Minimum clearances during operation as follows:
• Heat emanating from the front of this heater may over time affect the appearance of
some materials used for flooring such as carpet, vinyl, cork or timber. This effect
may be amplified if the air in the room contains cooking vapours or cigarette
smoke. To avoid this possibility, it is recommended that a mat be placed in front of
the appliance, extending at least 750 mm in front of the air outlet.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Young Children must be supervised when in the vicinity of this heater while it is in
operation.
• The Mesh Dress Guard MUST be fitted to this appliance to reduce the risk injury
from burns and no part of it should be permanently removed.
• For protection of young children or the infirm a secondary guard is required.
WARNING
On heat sensitive
surfaces provide
protective matting
to at least 750mm
Non-combustible
cladding MUST
be provided for
RDV3610ETR
installations.
NOT required on
RDV3611ETR
installations.