Manualshelf

Installation manual

ManualsBrandsRinnai ManualsHome building and DecorSymmetry RDV3611
31323334353637383940
Rinnai Australia 33 Installation Manual
HEATER INSTALLATION
ABNORMAL FLAME PATTERN
The Rinnai Symmetry
®
heater has a distinct flame pattern. This should look the same every time you
start your heater, after an initial warm up period of approximately 20 minutes.
Abnormal flame performance and/or pattern can indicate a problem with your heater, such as blocked
gas injectors or the artificial logs/burn media have shifted from when the heater was first installed.
There are some warning signs that could indicate a problem. If any of the signs occur, please call
Rinnai.
Step 13. FIT THE SURROUND
Fit the surround in reverse order to ‘Step 3 (2) page 26.
Step 14. REPLACE MESH DRESS GUARD & DRESS GUARD FRAME ASSEMBLY
Replace Mesh Dress Guard & Mesh Dress Guard Frame assembly in reverse order of ‘Step 3 (1)’
page 26.
The dress guard fitted to this appliance reducing the risk of fire and injury and no part
of it should be permanently removed.
For protection of young children or the infirm a secondary guard is required.
If the heater is not operating correctly refer to the Trouble Shooting before contacting
Rinnai.
It is the responsibility of the installer to check that under normal operating conditions
of the appliance, all flue gases are exhausted to the outside atmosphere and that
there is no spillage of combustion gases into the room. Please refer to
AS/NZS 5601.
During the initial burning in period of approximately 2 hours, some smoke and smell
may be experienced. During this period the heater should be operated on High and
the space being heated should be well ventilated. It may take up to 20 minutes of
operation for the logs to achieve their full flame pattern and glow.
Burner aerations are factory set and can not be adjusted. If you are unable to get the
unit to operate correctly refer to Trouble Shooting section of this manual before
contacting Rinnai.
Normal Abnormal
Signs of abnormal flame performance:
• Continuous Unusual smell from the appliance.
• Continued difficulty or delay in establishing a flame.
• Flame appears either very short or very long.
• Flame only burns part way across the burner.
• Severe soot building up on the inside of the glass door.
WARNING
NOTE