Installation manual

Rinnai Australia 14 Operation & Installation Manual

HOW TO OPERATE YOUR HEATER

MANUAL SWITCH MODE

If you lose your remote controller or the batteries go flat you can

still operate your unit in * ‘Manual Switch Mode’.

Step 1. Press ‘ON’/‘OFF’ button until the sparker can be

heard. The button is discretely located on the ‘Manual

Control Switch Panel’ at the bottom right of the heater.

Step 2. Once the electronic sparker has activated the pilot flame will ignite, the main burner will

ignite off the pilot and automatically go to Stage 7-High Flame. The red LED Power

Indicator will be constantly illuminated indicating heater operation in ‘Manual Switch

Mode’.

Step 3. To turn the heater ‘OFF’ press the ‘ON’/’OFF’ Button . The red LED Power Indicator

will flash indicating that the appliance has functioned in ‘Manual Switch Mode’ and is

independent of the remote controller.

If the controller is lost or if the batteries go flat the unit will operate as described

above, however, extreme caution must be used because the appliance will continue

to operate on ‘HIGH’ setting only, NO lower adjustment of temperature is possible

without the thermostatic controller.

LOSS OF REMOTE CONTROL FUNCTION

* Note: Once the 'Manual Switch Mode' has been selected the heater will only operate by pressing

the ‘Manual Switch’, once you have pressed the ‘Manual Switch’ the heater will not respond to the

remote controller.

TO REGAIN REMOTE CONTROL

Step 1. Turn the heater 'on' with the 'Manual Switch', follow steps 1 and 2 of “MANUAL SWITCH

MODE” above.

Step 2. On your remote control hand set, select refer to “MANUAL TEMPERATURE MODE” on

page 11 for 'Manual Mode'.

Step 3. Press the 'UP' or 'DOWN' button to raise or lower the temperature, this will send a signal to

your heater reinstating remote control.

Step 4. Remote Control has now been reinstated and normal programming can be selected.

GAS SUPPLY DISRUPTION

Should disruption to gas supply occur the appliance will go into 'lockout' after sparking for 1

minute. Under 'lockout' the red LED Power Indicator will remain illuminated. To start the

appliance again, press and release the 'ON / OFF' button twice after gas supply resumes.

POWER DISRUPTION

In the event of power failure / disruption the heater will turn 'OFF' and will need to be manually

turned 'ON' again when power is restored. This is a safety feature. Refer to, “* Note: Once the

'Manual Switch Mode' has been selected the heater will only operate by pressing the ‘Manual

Switch’, once you have pressed the ‘Manual Switch’ the heater will not respond to the remote

controller.” on page 14.

NOTE