Installation manual

Rinnai Australia 10 Operation & Installation Manual
REMOTE / THERMOSTAT CONTROL
WIRELESS CONTROLLER THERMOSTAT
The wireless controller is designed to be wall mounted on a bracket, (bracket supplied with the
controller), within 20 m of the heater.
The controller houses the thermostat which senses room temperature and communicates back to the
Symmetry
®
via Radio Frequency.
The ideal position for the controller is:
• Away from possible drafts in the room.
• Away from direct sunlight.
• Suitable distance away from the heater.
• Ideally 1.5 m from the floor, (approximately at chest height).
Battery:2 x AA batteries.
Battery Life: Approximately 12 months.
Dimensions:
Height: 140 mm
Width: 80 mm
Depth: 20 mm
Additional information about Remote Thermostat Control Buttons
Transmit Indicator Indicates the thermostat is transmitting to the receiver, the symbol
with appear on the LCD for 1 second.
Battery Indicator This symbol will flash when batteries need replacing. The
thermostat will remain functional for approximately 5 days before
shutting ‘off’.
Temperature Display Displays current temperature. °C is the default but °F is available.
The temperature range is 7 - 32°C.
Room or Set Indicator When the thermostat is ‘ON’ the programmed (set) temperature
and the room temperature will be displayed. When the Flame
mode is ‘ON’ the Flame setting F7 to F1 will be displayed
PWR + OK Switches the thermostat ‘ON’ and ‘OFF’. If thermostat is ‘OFF’,
pressing and releasing the ‘PWR’ + ‘OK’ button will turn the
thermostat on to the most recently selected working mode.
T - (Time) Initiates the time and day of week programming, press and hold
for 2 seconds.
UP, OK, and DOWN ‘UP’ increment hours, minutes, day or temperature ‘OK’, accepts
the current function and advances to the next function, ‘DOWN’,
decrement hours, minutes, day or temperature.
P - (Program) Initiates the programming mode, press and hold for 2 seconds.