Installation manual

Rinnai Australia 9 Operation & Installation Manual
REMOTE / THERMOSTAT CONTROL
REMOTE CONTROLLER - INITIAL SET UP
Before you start
Carefully remove the battery compartment cover panel from the rear of your controller hand-set
and correctly insert the two AA batteries supplied ensuring '+' and '-' polarity is correct.
When installing your batteries your remote control will display the 'Initial
Set-up Screen'. The screen will display the following:
• Current room temperature in Deg.C
• Default time setting of
• Default day of the week setting ‘MO’ - Monday.
When changing batteries all settings will be lost and the controller will revert back
to the 'Initial set -up screen'.
Setting the Current Time and Day of the Week
Step 1). Install batteries by removing the cover at the rear of the remote
controller unit.
Step 2).Press and hold the ‘T’ button for approximately 2 seconds.
‘TIME’
, ‘HOUR’ and ‘A/M’ will flash.
If no buttons are pressed the display will revert back to 'Initial Set-Up Screen'
retaining the last entered setting.
Step 3).To select the hour push the
‘UP’ or ‘DOWN’ button until the
desired hour is chosen, note that AM or PM is chosen by cycling
through the 12 hour range.
Step 4). Press ‘OK’ to enter the selected hour and
AM or PM. ‘TIME’ + minutes + ‘A/M’ will
flash.
Step 5). To select the minutes push the ‘UP’
or ‘DOWN’ button until the
desired minutes are chosen. (See Step 3 for ‘UP’
and ‘DOWN’
Buttons).
Step 6). Press ‘OK’ to enter selected minutes, the ‘MO’ Monday will
flash. (See Step 4 for ‘OK’ Button).
Step 7). To select correct day push the ‘UP’
or ‘DOWN’ Button until the
desired day is chosen. (See Step 3 for ‘UP’
or ‘DOWN’
Buttons).
Step 8). Press ‘OK’ to enter the selected day, time & day are now correctly set.
(See Step 4 for ‘OK’ Button).
To adjust time for Daylight Saving time
To adjust time or to adjust for daylight savings follow Steps 2 - 6 press ‘OK’
button twice after
selecting minutes to keep current day.
When changing batteries all settings will be lost and the controller will revert back
to the 'Initial set -up screen'. Re-setting of time, date and programming will be
necessary.
NOTE
MO
NOTE
A/M PWRTP
DOWN
UP
OK
A/M PWRTP
DOWN
UP
OK
MO
NOTE