Installation guide

RDV3611 Installation Manual: 11156-A 01-12 | 21
1. Carefully remove log set from
packaging and fit the Front
Base Left Log in the created
gap. It should only fit one
way.
2. Fit Front Base Right Log into
position on the far right of the
burner base.
3. Fit Front Middle Left Log into
the back flat section of the
burner, and slot on top of the
Front Base Left Log.
4. Place Front Middle Right Log
into the u-shaped groove.
5. Place the Top Log onto the
recessed sections of the left
and right middle logs. Ensure
the middle elbow section rests
on the top of the Bottom Log.
6. Position the Round Flat Rock
and Front Left Rock over the
screw holes. Keep them as
far away as possible from the
glass, while making sure they
still cover the holes. Place the
remaining Triangular Shaped
Rock on top of the Round Flat
Rock as shown.
1.
2.
3.
4.
5.
6.