Installation manual

Rinnai Australia 17 Operation & Installation Manual
REMOTE / THERMOSTATIC CONTROLLED OPERATION
Step 4. To select the ‘ON’ hour for ‘P1’ push the ‘UP’ button or ‘DOWN’ button until the desired hour is
chosen, note that AM or PM is chosen by cycling through the 12 hour range.
Step 5. Press the ‘OK’ button to enter the selected hour and AM or PM. ‘TIME’ + ‘MINUTES’ + ‘AM or PM’
will flash.
Step 6. To select the ‘ON’ minutes for ‘P1’ push the
‘UP’ button or ‘DOWN’ button until the desired
minute is chosen.
Step 7. Press the ‘OK’ button to enter the ‘ON’ minutes. ‘SET’ + ‘TEMPERATUTRE DIGITS’ will flash.
Step 8. To select the ‘ON’ temperature for ‘P1’ push the
‘UP’ button or ‘DOWN’ button until the desired
temperature is chosen.
Step 9. Press the ‘OK’ button to enter the selected temperature. The LCD will display ‘PROG’. ‘P2’ and the
‘TIME’ + ‘HOUR’
+ ‘AM’ will flash, this completes the programming for the ‘P1 - ON’ period. Repeat
steps 3 through 9 for ‘PROG’. ‘P2 - OFF’, ‘P3 - ON’ and ‘P4’ ‘OFF’ periods.
10
15
STEP 4
A/M PWRTP
DOWN
UP
OK
A/M PWRTP
10
STEP 5
A/M PWRTP
DOWN
UP
OK
A/M PWRTP
DOWN
UP
16
STEP 6
A/M PWRTP
DOWN
UP
OK
A/M PWR
OK
TP
10
15 15
11
10
15
STEP 9
A/M PWRTP
DOWN
UP
OK
A/M PWRTP
DOWN
UP
16
STEP 7
A/M PWRTP
DOWN
UP
OK
A/M PWR
OK
TP
STEP 8
A/M PWRTP
DOWN
UP
OK
A/M PWR
OK
TP
10
16
15
11
10
15
11