Installation manual

Rinnai Australia 14 Operation & Installation Manual
REMOTE / THERMOSTATIC CONTROLLED OPERATION
TO TURN YOUR HEATER ON WITH REMOTE / THERMOSTATIC CONTROL
MODES OF OPERATION
To Turn Remote ‘ON’ or ‘OFF’
Step 1. To turn ‘ON’ - press and release the ‘OK’ button and ‘PWR’ button at the same time. The
display will now include the setting temperature and the mode of operation.
Step 2. To turn ‘OFF’ - press the ‘PWR’
button only.
Manual Temperature Mode
• Temperature can be set at any level.
• Time and day of week does not need to be programmed to operate.
Step 1. With the controller turned ‘ON’, press and release the ‘A/M’ button until the word ‘MANUAL’
appears on the LCD.
Step 2. Press the
‘UP’ button or ‘DOWN’ button to increase or decrease the temperature in increments
of 1°C.
BEFORE PROCEEDING ENSURE THE GAS
AND ELECTRICITY ARE TURNED ON.
Before remote / thermostatic control can be
used the heater must be taken out of the OFF/
STANDBY condition (supply connected and
switched ON but the heater turned OFF), do
this as follows:
Press ‘ON’/‘OFF’ button once the electronic
ignition sparker will be able to be heard.
The electronic ignition stops when the pilot flame has been established. The main burner then
ignites off the pilot. Once the main burner has ignited the heater can then be operated by remote /
thermostatic control.
NOTE
a
b
c
d
a
b
Control for square fronted fasciaControl for bevelled fronted fascia
a
A/M PWRTP
DOWN
UP
OK
A/M TP
DOWN
UP
A/M PWRTP
DOWN
UP
OK
A/M TP
DOWN
UP
11 12 12
STEP 1 STEP 2
11
12
12
A/M PWRTP
DOWN
UP
OK
PWR
OK
TP
DOWN
UP
STEP 1 STEP 2
13
A/M PWRTP
DOWN
UP
OK
A/M PWR
OK
TP
15
10
13
10
15