Operating instructions

Rinnai New Zealand Limited RDV3610 Operation Manual: 11620-D
04-10
9
General information
Before operation
Read these instructions to get an overview of how to operate, maintain and service your
Rinnai Symmetry RDV3610.
Cladding and nishes
The Symmetry RDV3610 comes in two framing options; framed and frameless. Framed is best
suited to a dry wall/plaster nish, the frameless option suits cladding with a nished edge such
as tiles, brick or polished granite. Both options are shown below to highlight the difference.
With the framed and frameless installation the re is a permanent xture. The re is screwed
to the framing before the cladding. Once the cladding has been xed in place the Symmetry
RDV3610 has been framed into a permanent position.
The depth of the Symmetry RDV3610 is adjustable to accommodate a range of cladding op-
tions. This is important for a frameless installation to achieve a ush nish. Where the edge is
visible an aluminium edge can be used to hide the visible cladding.
Frameless
Framed
Electrical connection
The standard electrical connection is to the right hand side of the heater front
assembly. If necessary this can be changed by your electrician to terminate on the left.
The connection is either direct wired or connected to a power point within the cavity.
A 1500 mm power cord is supplied with a 3-pin plug. This must be connected to a dedicated
earthed power point. The electric isolation switch must be accessible after the appliance has
been installed.
The heater must not be located immediately below a socket outlet (potential re hazard).
If the supply cord is damaged, it must be replaced by a licensed tradesperson. This must be a
genuine replacement part available from Rinnai, part number 6765B.