Operating instructions

Rinnai New Zealand Limited RDV3610 Operation Manual: 11620-D
04-10
17
Operation using the controller
Turningonand
off
Press the ‘OK’ and ‘PWR’ button at the same time to ignite the heater. This
is a safety feature to reduce the chance of young children being able to
turn on the unit.
The unit rst lights to pilot and then after a period switches to the high
setting.
To turn off press and release the ‘PWR’ button.
Changebetween
manual,
automatic,and
amemode
Press and release the ‘A/M’ button.
Changingthe
temperature
The Symmetry RDV3610 has seven stages of temperature/ame
modulation which can be changed using the ‘UP’ and ‘DOWN’ buttons.
Your temperature control range is 7
*
-32 ˚C.
There is also a setting before 7 ˚C that is –– °C. This means no set
temperature has been programmed (p. 15).
Ifthe
controllerisnot
synchronised
The wireless controller will be factory set so synchronising will only be necessary if there is an
error or if the controller has been purchased separately. Synchronising involves the wireless
controller sending a signal to the re so that it can memorise the certied frequency that it
operates on.
Only perform if the wireless controller is not synchronised (Symmetry
RDV3610 will not operate when any of the functions are selected on the
controller).
With the controller off, press the following sequence of buttons:
P > T > T > UP
The LCD display will show ‘CL’ (Code Learn) for two seconds then return
to the normal OFF state display. During this time a special code will be
transmitted by the RF controller to the Symmetry RDV3610.
*
This does not indicate cooling functionality. The lower temperature range is in colder
climates where room temperatures could fall below 7 ˚C.
Changebetween
°Cand°F
The thermostat display can be set to °C or °F. The default is °C.
With the thermostat off, press the following sequence:
P > T > T > A/M