Operating instructions
Rinnai New Zealand Limited RDV3610 Operation Manual: 11620-D
04-10
14
Modes of operation
Manual mode
• Temperature can be set at any level
• Time and day of week does not need to be set
With the controller turned on, press and release the A/M button until the word ‘MANUAL’
appears on the LCD. Press and hold the ‘UP’ and ‘DOWN’ buttons to increase/decrease the
temperature by 1 °C.
Automatic mode
• Temperature is regulated to a programmed level and time (p. 15)
• Time and day of week needs to be set
• At any time the temperature may be adjusted up or down
Flame control mode
Allows you to set your preferred ame setting and override the set temperature—your heater
will not automatically turn itself off (unless the room exceeds 40 °C).
To activate the ame mode:
1. Turn the controller on (PWR and OK).
2. Press the A/M button until the MANUAL or AUTO symbol disappears from the bottom of the
LCD.
3. The LCD will display the following. Use the UP and DOWN button to adjust the ame setting
(seven ame stages in total). When using for the rst time, the controller will default to F1
(lowest setting), and then default to the last selected ame setting when used again.
Flamemode, nothing will be displayed in this window when
operating in ame mode.
A/M PWRT P
DOWN
UP
OK
Flamesetting,ame symbol will correspond to ame setting
selected. F7-F1 (highest to lowest).