Operating instructions
Rinnai New Zealand Limited RDV3610 Operation Manual: 11620-D
04-10
13
Operation of your RDV3610
Child lock
The controller has a built-in child lock function that requires pressing two buttons
simultaneously. This function cannot be overridden.
To turn the controller on, press PWR and OK at the same time. Pressing PWR will switch the
controller off.
Fan
On start-up, the fan will start approximately four minutes after the heater is switched on. This
delay is to reduce the amount of cold air being pushed out into the room.
On shut-down, the fan will stop approximately eight minutes after the heater is switched off.
This is to cool the appliance down.
Modes of operation
Your RDV3610 has three modes of operation:
1. Manual (set temperature) mode
2. Automatic (programmed timer and temperature) mode
3. Flame control mode
Important
The RDV3610 is designed to run as efciently as possible. When in manual or automatic
modes, the heater will switch itself off if the room reaches the set temperature, i.e. in smaller
rooms that heat up quickly. When this occurs, the ame indicator on your controller will rise
and fall every few seconds to indicate the RDV3610 is still operational. The heater will restart
again once the room temperature falls below the set temperature. ALWAYS check your wireless
controller before going to bed or leaving the building to ensure the heater has been switched
off.
If you want the RDV3610 to operate regardless of room temperature, you can adjust the
controller to ame control mode only (p. 14).
Start-up
When turning the RDV3610 on, the heater will automatically go to the highest setting for
approximately 45 seconds—this is to establish the ame pattern. You can adjust the heater
during this period but there will be a 45 second delay.
Over temperature automatic shut off
The controller when operating in any of the three modes will automatically shut down and
switch the heater off if the room temperature exceeds 40 °C for more than three minutes—this
is a safety feature.