Installation Guide

Rinnai 3 Smartbox SBOXI/SBOXC/SBOXF

DIMENSIONS

The Rinnai water heater serial and model numbers on the data plate located on the left hand side of the

appliance MUST BE copied to the sticker on the inside of the Smartbox cover. The serial and model

numbers are required for future service work.

5. Remove the two M5 Nyloc nuts from the fixing studs

of the insert.

6. Insert the upper mounting bracket of the Rinnai water

heater into the bracket slot located at the top of the insert.

7. Push the appliance up until the lower mounting bracket

aligns with the fixing studs and secure in place with the

two M5 Nyloc nuts removed in step 5.

8. Connect the Rinnai water heater in accordance with the

Operation / Installation manual supplied with the water

heater.

9. An approved weatherproof electrical GPO can be fitted on

either side inside the insert in accordance with AS 3000

Wiring Rules.

10.Commission and test the water heater in accordance with the Operation / Installation manual supplied with the water

heater.

11.Attach the warning sticker that is supplied with these instructions to the front cover of the Rinnai water heater.

12.Install the Smartbox cover by aligning it with the Smartbox insert (the flue spigot hole is to be uppermost) and push

into place ensuring that the 4 locking clips have engaged securely.

IMPORTANT

3 4