User Manual

Rinnai 8 ORH OIM
GENERAL DESIGN LAYOUT / CARTON CONTENTS
The packaging for this appliance should contain:
1. Outdoor Radiant Heater: a. Heater body b. Front radiating surface.
2. 1000mm Flexible power cord with three pin plug (tted)
3. Operation Indicator Light
4. Adjustable angle mounting bracket ttings (x2)
5. Mounting bracket locking plates (x2)
6. Operating & Installation Instructions
7. Remote Control
OPERATION
1� Before operating the heater for the rst time or after periods of non use ensure that the radiating surface is
clean and free of debris or dust see "Cleaning" on page 14.
2� Ensure that the GPO for the heater is in the "ON" position, then switch "ON" the power at the isolating switch
(if tted).
4
5
1b
2
3
5
6
1a
4
Outdoor Radiant Heater
Operation & Installation Manual
Models:
ORH15R
ORH18MR
ORH24LR
ORH32XLR
7
NOTE
Ensure that the power switch on the right hand side of the appliance is set in the ‘I’ position when
installing.
hour
on off
1 2
64
Red
indicator
Remote
control
Power
switch to ‘I’
position
ABOUT YOUR OUTDOOR RADIANT HEATER