Installation manual

ManualsBrandsRinnai ManualsHousehold AppliancesMC 91 1A

Rinnai Australia 14 Installation Manual

WIRELESS WATER CONTROLLER INSTALLATION

INSTALLING MULTIPLE WIRELESS WATER CONTROLLERS

To install subsequent wireless water controllers repeat steps 2 to 8 for each additional wireless water

controller.

Once all wireless water controllers are installed re-secure the transceiver access cover.

TROUBLE SHOOTING WIRELESS WATER CONTROLLERS CHANNEL ASSIGNMENT

If at the end of the installation process screen (C) is

displayed do the following:

Confirm first that the power is still on at the water

heater.

If power is off turn it back on. If the channel has been

correctly assigned then the display should show

either screens (E), (F) or (G).

If screen (C) is still displayed un-install

and reset the wireless controller and

repeat the installation procedure.

UN-ASSIGNING AND RESETTING WIRELESS WATER CONTROLLERS

1. Press the desired controller channel button .

The LED will go out to signify that this channel is

now un-assigned.

2. Removing the batteries from the wireless

controller will reset the wireless controller and

complete the un-install process.

INSTALLING WIRED AND WIRELESS WATER CONTROLLERS

When installing combinations of both wired and wireless controllers, all wired water

controllers MUST BE connected before the wireless water controllers are assigned to

a transceiver channel.

Refer to page 1 to confirm the maximum number and combination of water controllers

that can be fitted

Wired water controllers can ONLY be added to an existing wireless installation when:

• All wireless transceiver channels have been un-assigned.

• All wireless controllers have been reset.

See “UN-ASSIGNING AND RESETTING WIRELESS WATER CONTROLLERS” above.

When the wireless transceiver is installed it automatically detects any wired

water controllers already connected to the water heater.

The LEDs of the channels assigned to wired controllers will slow flash.

The channels for wired water controllers are assigned in sequence as

follows:

MC100V or MC91 (programmed as a Master Controller) will automatically

be assigned to the MC channel.

BC100V or MC91 (not programmed as a Master Controller) will

automatically be assigned to an available channel other than the MC

channel.

Install the wireless water controllers to any of the unassigned channels

following steps 1 to 9 on page 13.

(C)

(F) (G)(E)

NOTE

No. 1 No. 2 No. 3

IMPORTANT