Installation manual

Rinnai Australia 13 Installation Manual
WIRELESS WATER CONTROLLER INSTALLATION
INSTALLING WIRELESS WATER CONTROLLERS
This installation procedure applies to wireless water controller installations only. For
combined wired and wireless water controller installations refer to “INSTALLING
WIRED AND WIRELESS WATER CONTROLLERS” on page 14.
Up to 4 wireless water controllers can be installed. Only one of these can be
designated as a 'Master Controller' (MC), others will be designated as 'Sub' controllers.
Only one wireless water controller can be installed at a time. DO NOT insert batteries
until step 3.
1. Ensure the power to the water heater is switched ‘on’.
2. Press the ‘Entry’ button on the transceiver for approximately 2
seconds to select a wireless controller channel for tuning. The first
unassigned wireless controller channel LED will begin a fast flash,
signifying that this channel has been selected for tuning.
The default order of channel selection is as follows:
The wireless Master Controller is the only wireless controller capable of selecting
maximum delivery Temperatures exceeding 50°C. Ensure that the Master Controller
(Kitchen) label provided is placed on the top rear of the assigned controller.
3. Select a wireless water controller for tuning to the
unassigned transceiver channel and remove the
controller from it’s wall mounting bracket. Open
the battery compartment with a full turn anti-
clockwise. Insert the batteries observing the
correct polarity. Close the battery compartment
with a full turn clockwise
4. After battery installation the wireless controller will momentarily display an initialisation screen (A),
which will then switch to screen (B) or (C).
5. If screen (B) is displayed press and hold the ‘On/Off’ button until screen (C) is displayed. This
takes approximately 2 seconds.
6. From screen (C) press the ‘On/Off’ button once to start the tuning process which will take
approximately 5 seconds. Once the controller is tuned the controller channel LED on the
transceiver will become steady and the controller LCD will switch to screen (D) or (E).
7. From screen (D) press the ‘On/Off’ button once or from screen (E) press the ‘Transfer’
button once to complete the tuning of this channel. At this point screen (F) will be displayed by the
controller. The wireless water controller is now tuned and ready to control the delivery temperature
of the water heater.
8. Apply one of the self-adhesive identification stickers to the rear of the controller, ensuring that the
Master Controller sticker is only applied to the wireless water controller tuned to channel MC.
IMPORTANT
a
EntryEntry
Controllers
MC
No. 1 No. 2 No. 3
a
NOTE
Full turn
clockwise
turn to close
Full turn
anti-clockwise
turn to open
b
b
(C)
OR
Press for
approximately
3 seconds
(B) (D)
(E)
Press once
(A)
Press once
to start the tuning
process, this takes
approximately
5 seconds
Press once
OR
(F)