Installation Guide
Rinnai Australia 9 Flue Installation Manual
CLEARANCES
Flue terminal Fan assisted flue appliance only Gas meter Electricity meter or fuse box Mechanical air inlet
Natural draft Fan assisted
Appliances 002003tupni h/JM 05 ot pu
Appliances 003005tupni h/JM 05 revo
003003* ecafrus rehto ro ynoclab a evoba ,dnu
org eht morFb
003005* renroc lanretxe ro llaw nruter a tnorFc
d
From a gas meter (M) (see 5.11.5.9 for vent terminal location of regulator )
00010001)stnemeriuqer dnalaeZ weN r
of 6.6 elbaT ees(
e From an electricity meter 005005† )P( xob esuf ro
57051epip lios ro epip niard a morFf
g Horizontally from any building structure* = or obstruction facing a terminal 500 500
h From any other flue terminal , cowl, or combustion air intake † 500 300
Appliances 003005* tupni h/J
M 051 ot pu
Appliances over 150 MJ/h input up to 200 MJ/h input * 1500 300
Appliances over 200 MJ/h input up to 250 MJ/h input * 1500 500
Appliances 00510051* tupni h/JM 052 revo
flue appliances , in the direction of discharge 1500
00010051rewolb aps
a gnidulcni ,telni ria lacin
ahcem a morFk
051051tupni rh/JM 05 ot pu sretaeh ecapS
appliances 005005tupni rh/JM 05 ot pu
Appliances over 50 MJ/h input and up to 150 MJ/h input 1000 1000
Appliances 00510051tupn
i h/JM 051 revo
1
Where dimensions c, j or k cannot be achieved an equivalent horizontal distance
measured diagonally from the nearest discharge point of the terminal to the opening
may be deemed by the Technical Regulator to comply.
2
See Clause 6.9.4 for restrictions on a flue terminal under a covered area.
3
See Figure J3 for clearances required from a flue terminal to an LP Gas cylinder.
flue terminal is considered to be a source of ignition.
4
metI.feR
a
Min. clearances (mm)
Below eaves, balconies and other projections:
j
NOTES:
FIGURE 6.2
appliance is certified for closer installation
For appliance s not addressed above acceptance should be obtained from the Technical Regulator.
n