User manual

REU-V1616W/REU-V2018W/REU-V2020W - 10 - Issue 1 - 10/10/03 ©Rinnai

5. Remote Controls

Remote Controls

Remote Controllers are an optional extra. 'Standard' controllers can be fitted.

Standard controllers allow temperature selection only. For detailed information

regarding controller operation refer to the 'How to use your water heater' booklet

supplied with the appliance. Other manufacturers' controllers are NOT

compatible with this appliance.

Standard Controller (Model MC-91)

Up to 3 Standard Controllers can be fitted to the appliance. They are normally

installed in the areas where the majority of hot water is used, for example, the

kitchen, bathroom, ensuite and laundry.

Positioning of Controllers

Controllers must be installed in shaded and clean locations. They should be fitted out of reach of children

(suggested height from floor at least 1500mm). Controllers are water resistant, however, durability is

improved when positioned outside the shower recess or at least 400mm above the highest part of a sink,

basin or bath.

DO NOT INSTALL THE CONTROLLERS

• NEAR A HEAT SOURCE, SUCH AS A COOK TOP, STOVE OR OVEN. HEAT, STEAM,

SMOKE AND HOT OIL MAY CAUSE DAMAGE

• IN DIRECT SUNLIGHT

• OUTDOORS UNLESS AN ENCLOSURE IS PROVIDED WHICH PROTECTS THE

CONTROLLER AGAINST SUNLIGHT AND DUST INGRESS.

• AGAINST A METAL WALL UNLESS THE WALL IS EARTHED IN ACCORDANCE

WITH LOCAL REGULATIONS.

Remote Controller Connection

Remote controls operate at extra low voltage (12 Volts DC) which is supplied from the appliance.

Controllers are supplied with 15 m of electrical cable. The cable wires for connection to the appliance are

fitted with spade terminals.

Extension cables are available from Rinnai. Alternatively, a two core sheathed (double insulated) flex with

minimum cross-sectional area of 0.5 mm² can be used. Maximum cable length is 50 m.

For connection refer to the “CONNECTING REMOTE CONTROL CABLES” section.

If the front cover of the appliance contains the following text install it in accordance with Diagram 1 below:

120

MC-91-1A

Service Manual Infinity 16e and 20e