User Manual
Rinnai 6 Dry-Soft® RD-400/600AU Operation Manual
OPERATION IN AUTOMATIC MODE
1. Open the dryer door and place items selected for drying evenly into the dryer drum. Close the
dryer door and press the 'On/Off' button . The default drying programme is set to GENERAL
+ EXTRA SOFT and these mode indicators will be illuminated.
2. To select an alternative drying programme press the 'Programme' button until the desired
mode indicator illuminates. The drying programmes cycle through the following sequence:
3. Press the 'Start / Pause' button . The 'OPERATING’ (Combustion) indicator will show
green, and will change to red after burner ignition which may take up to 10 seconds.
4. Drying will now commence. The approximate remaining drying time will be indicated on the digital
display . The 'OPERATING’ (Combustion) indicator may alternate between showing green
and red, however this is normal.
5. The dryer will stop when items are sufficiently dry. A tone will sound 3 times and the 'FINISH'
indicator will illuminate.
OPERATION IN TIMER MODE
1. Open the dryer door and place items selected for drying evenly into the dryer drum. Close the
dryer door and press the 'On/Off' button .
2. Press the 'Timer' button , the ‘TIMER’ indicator illuminates and the default drying
programme is GENERAL and this mode indicator will be illuminated.
3. There are only two drying programmes available in “Timer’ mode, these are
GENERAL and DELICATE , press the 'Timer' button until the
desired programme mode indicator illuminates.
4. The default drying time in minutes is shown on the digital display . Change the drying time by
pressing the 'up' or 'down' buttons. The drying times that can be selected are
5,10,15,20,25,30,40,50,60,70* and 80* minutes (*Dry-Soft 6 model only).
5. Press the 'Start / Pause' button , the ‘TIMER’ indicator will begin to flash to signify that a
‘Timer’ operation has begun. The 'Operating / Combustion' indicator will show green and will
change to red after burner ignition which may take up to 10 seconds.
6. Drying will now commence. The approximate remaining drying time will be indicated on the digital
display and will counted down in 5 minute increments. During operation the time may be
increased and decreased as desired by pressing the 'up' or 'down' buttons. The
'OPERATING’ (Combustion) indicator will show green towards the end of the drying cycle, this
is normal.
7. The dryer will stop when the drying time has elapsed. A tone will sound 3 times, the ‘TIMER’
indicator will stop flashing and the 'FINISH' indicator will be illuminated.
Before opening the dryer door, ensure the 'OPERATING’ (Combustion) indicator
shows green.
If the dryer door is opened and closed during operation the dryer will go through a
cool down, purge and relight sequence that takes approximately 1 to 2 minutes.
The 'default' drying time is 20 minutes when the appliance is first connected to the
electric power supply. If the appliance has operated in timer mode previously the
previous drying time selected will be shown as the default drying time.
Before opening the dryer door, ensure the 'OPERATING’ (Combustion) indicator
shows green.
If the dryer door is opened and closed during operation the dryer will go through a
cool down, purge and relight sequence that takes approximately 1 to 2 minutes.
1
7 9
3
GENERAL + EXTRA SOFT THICK+ EXTRA SOFTGENERAL THICK DELICATE
2
11
15 11
12
NOTE
11
1
4
13
7
GENERAL
DELICATE
7 10 4
15
5 6
NOTE
2
13
9
15
5 6
11
13 12
NOTE
11
OPERATION