Installation manual

Rinnai Australia 2 Energysaver® - Operation & Installation Manual
Important
Unpack the heater and check for damage. DO NOT INSTALL DAMAGED HEATER. If the heater is
damaged, contact your supplier for advice. Before installing the heater, check the label for the correct
gas type (refer rating plate, right hand side panel).
Refer to local gas authority for confirmation of the gas type if you are in doubt.
Important Points
1. The appliance must be installed in accordance with the local gas and electrical authority regulations.
2. For information on gas consumption, refer technical specifications on page 17 and check with the
data plate on the appliance.
3. This appliance must not be installed where curtains or other combustible materials could come into
contact with it. In some cases curtains may need restraining.
4. Heater must not be located below a power socket-outlet.
5. The local gas and electrical authorities will be able to advise on local regulations.
6. Only the approved flue components specified by Rinnai must be used.
1. The appliance must be installed in accordance with the local gas and electrical
authority regulations.
2. DO NOT connect to an LPG Gas cylinder indoors.
3. A dedicated 240 V earthed 10 Amp power point must be used with this
appliance.
4. Heat emanating from the front of this
appliance may over time affect the
appearance of some materials used for
flooring such as carpet, vinyl, cork or
timber. This effect may be amplified if the
air in the room contains cooking vapours
or cigarette smoke. To avoid this
possibility, it is recommended that a mat is
placed in front of the appliance, extending
at least 750 mm in front of the air outlet.
5. The appliance is not intended for use by young children or infirm persons
without supervision.
6. This appliance is not intended for use by persons (including children) with
reduced physical, sensor or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instructions
concerning use of this appliance by a person responsible for their safety.
7. Young children should be supervised to ensure they do not play with the
appliance.
8. If the supply cord is damaged or require replacing, it must be replaced by the
manufacturer or the manufacturer's agent or similarly qualified person in order
to avoid a hazard.
9. DO NOT modify this appliance. Modifying it in any way or form, from original
specifications may create a dangerous situation and will void your warranty.
WARNING
AT LEAST
750 mm
SAFETY