Installation manual

Rinnai Australia 12 Energysaver® - Operation & Installation Manual
Pre-Heat
This function operates automatically in
conjunction with the Timers. When a Timer is
selected, the heater may operate anywhere
within an hour prior to the programmed starting
time on the Timer.
This function is called Pre-heat since it ensures
the room reaches the desired temperature by the
time the Timer programs ON time. The room
temperature is sensed one hour before reaching
Timers programmed ON time.
The temperature differential at the time of sensing the room temperature combined with the data from
previous operation governs exactly how long before the programmed ‘ON’ time the micro-computer will
operate the heater and ignite the burner.
Humidifier Tray
Your heater is fitted with an enamelled tray behind the air outlet so that you can humidify the air. To fill
the tray, open the access panel as shown in the diagram and pour water into the tray using the spout
built into the access panel. Do not fill the tray over 3/4 full.
The air will be humidified as it passes over the water in the tray.
Humidifier Tray may become hot!
DO NOT FILL THE HUMIDIFER TRAY WHILST THE HEATER IS IN
OPERATION.
DO NOT fill the humidifier tray for at least 5 minutes after the heater stops
operating.
DO NOT operate the heater without the humidifier tray in place.
If you notice water in the humidifier tray, but have not placed
any there do not be alarmed, this is normal. Due to the high
efficiency of Energysaver
®
heaters, water in the form of
condensate is accumulated in the flue system which drains
into the humidifier tray.
If the humidifier is in use, it will need filling approximately
about once a day during the heating season.
Vertical Louvre Adjustment
The warm air flow direction may be altered by carefully
inserting a screwdriver or similar tool and gently bending the
vertical louvre(s) either to the left or the right.
NOTE: These louvres are not designed to be adjusted
more than 6 times.
Outside Flue Terminal
On cold days steam may be discharged from the flue terminal. This is normal with high efficiency
appliances such as the Energysaver
®
range and does not indicate any fault.
CAUTION
Pull
Humidifier Tray
Gently Remove
Access Panel
Pull
OTHER OPERATING INFORMATION