Installation Sheet

14 Fan Convector Manual
Consumer Operaon Guidelines for the Safe Operaon of your Fan Convecon Heater
FOR YOUR SAFETY READ BEFORE OPERATING
A. This appliance does not have a pilot. It is equipped
with an ignion device that automacally lights the
burner. Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the oor
because some gas is heavier than air and will sele
on the oor.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electric switch; do not use any
phone in your building.
Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instrucons.
If you cannot reach your gas supplier, call the re
department
C. Use only your hand to push the in or turn the gas
control knob. Never use tools, If the knob will not
push in or turn by hand, do not try to repair it; call
a qualied service technician. Force or aempted
repair may result in a re or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a licensed professional to
inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
WARNING
If you do not follow these instrucons exactly, a re or explosion
may result causing property damage, personal injury or loss of life.
TO TURN OFF GAS TO APPLIANCE
1. Turn o all electric power to the appliance using
the ON/OFF buon.
2. Set the thermostat to the lowest seng.
3. Turn the manual valve clockwise to the full
OFF posion.
OPERATING INSTRUCTIONS
1. STOP! Read the safety informaon above.
2. Set the thermostat to the lowest seng.
3. Turn o all electric power to the appliance using
the ON/OFF buon on the control panel.
4. This appliance is equipped with an ignion device
that automacally lights the burner. Do not try to
light the burner by hand.
5. Locate the manual gas valve on the back side of
the heater. Turn the manual valve clockwise to
the full OFF posion.
6. Wait ve (5) minutes to clear out any gas. Then
smell for gas, including near the oor. If you smell
gas, STOP! Follow “B” in the safety informaon
above. If you don’t smell gas, go to the next step.
7. Turn the manual gas valve counterclockwise
to the full ON posion.
8. Turn on all electric power to the appliance using
the ON/OFF buon.
9. Set the thermostat to desired seng.
10. Burner is lit when operaon lamp glows red.
11. If operaon lamp is ashing red,
burner has not been lit and an error
code will display.
12. If the appliance will not operate, follow the
instrucons “To turn o gas appliance” and call
your licensed service technician or gas supplier.