Owner's Manual

The party responsible for FCC compliance is:
Ring LLC, 1523 26th St, Santa Monica, CA USA,
90404
FCC Radiation Exposure Statement
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment
and it also complies with Part 15 of the FCC RF
Ru l es. This equipment must be installed and
operated in accordance with provided instruc-
tions and the antenna(s) used for this transmitter
must be installed to provide a separation distance
of at least 20 cm from all persons and must not
be co-located or operating in conjunction with
any other antenna or transmitter. End-users and
installers must be provided with antenna instal-
lation instructions and consider removing the
no-collocation statement.
For Consumers in Canada
This device contains licence-exempt transmitter(s)/
receiver(s) that comply wi th Innovation, Science
and Economic Development Canada's licence-ex-
empt RSS(s). Operation is subject to the fo l lowing
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
Information Regarding Exposure to Radio
Frequen cy Energy
This equipment complies with IC RSS-102 RF
exposure limits set forth for an uncontrolled
environment.
Rad io Frequency Compli a nce
In order to protect human health, this device meets
the thresholds for exposure of the general public to
electromagnetic fields according to Council Rec-
ommendation 1999/519/EC.
This transmitter must not be co - located or oper-
ating in conjunction with any other antenna or
transmitter. This equipment should be installed
and operated wi th a minimum distance of 20 cen-
timeters between the radiator and your body. Your
Ring Video Doorbell Wired is designed to replace
an existing doorbell button, and gets its power
from the doarbell system.
mm
&
SAFETY INFORMATION: FAILURE TO FOLLOW
THESE SAFETY INSTRUCTIONS COULD
RESULT IN INJURY .
Chime is for indoor use only. Do not expose
your device to liquids. If your device gets wet,
carefully unplug the device without getting
your hands wet and wait for the device to dry
completely before plugging it in again. Do not
attempt to dry your device with an external heat
source, such as a microwave oven or a hair dryer.
To avoid risk of electric shock, do not touch your
device or any wires connected to your device
during a lightning storm. If the device appears
to be damaged, discontinue use immediately.
Do not cover the device while operating. Do not
open the housing. Protect this device from sun-
light. Disconnecting the plug will power the device
off. Only pl ug this device into an easily accessible
socket-outlet.
WARNING : Changes or modifications to this unit
not expressly approved by the part,i responsible
for compliance could void the users authority to
operate the equipment. This equipment should be
installed and operated with minimum distance 20
cm between the radiator & your body.
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE : This equipment has been tested and
found to comply with the limits for a Class B dig-
ital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a res-
idential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equ ipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between
the equipment and receiver.
, Connect the equipment to a socket on a
circuit different from that to which the
receiver is connected.
, Consult the dealer or an experienced
radio/TY technician for help.
Pursuant to Section 15.21 of the FCC rules, changes
or modifications to a Product by the user that are
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
The device meets the FCC Radio Frequency Emis-
sion Gu i delines. Information on the product is on
file with the FCC and can be found by inputting
such Product's FCC ID (which can be found on the
device) into the FCC ID Search form available at
fcc.gov / oe t/ e a/ fcc id.
The party responsible for FCC compliance is Ring
LLC, 1523 26th Street Santa Monica, CA 90404.
To contact Ring about the device's FCC equipment
authorization, please write us at the address shown
above or contact us using the following address:
legal @ ring.com .Additional information regarding
the Chime FCC equipment authorization(s) can be
found at: ring. com /regulatory
Product Speci fi cations
Dev i ce Nam e: Chime (2nd Generation)
Model : SAT1S2
FCC ID : 2AEUPBHACM021
Electrical Rating : 100-240VAC~ 0.20A 50/60Hz
Temp era ture Rating: 32°F to 104°F (0°C to 40°C)
RECYCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic
devices is regulated. Make sure you dispose of, or
recycle, your device in accordance with your local
laws and regulations.
Terms of Se rv ice and Warr anty
By purchasing or using the product, you agree to
the Terms of Service found at ri ng .c om /t erms . For
information on our warranty, theft protection, and
Ring Protect Plans, see ri ng .co m /l egal .
R in g LLC 1523 26th St. Santa Monica, CA 90404 USA
© 2021 Ring LLC or its affiliates.
Ring and all related marks are trademarks
of Ring LLC or its affiliates.
22-003028-01