Owner's Manual

Important
Product
Information
•
ring
DOORBELL WIRED
&
SAFETY INFORMATION : FAILURE TO FOLLOW
THE SE SAFETY IN S TRUCTIONS C OULD
RESULT IN FIRE , ELECTRIC SHO CK,
OR O THER INJURY OR DAMAGE .
Your device can withstand outdoor use and
has been tested to withstand water projected
through a 6.3mm nozzle at a volume of 12.5 liters
per minute and a pressure of 30 kPa at a distance
of 3 meters for at least 3 minutes. However, your
device is not intended for underwater use. To
protect against electric shock, do not i ntent1on-
ally submerge or immerse your device, battery, or
adapter (not included) in water or expose your
device or adapter to other liquids. Do not spill
any food or beverages on your device, battery, or
adapter. Do not attempt to clean or polish your
device, battery, or adapter with or expose your
device, battery, or adapter to oil, lotion, or other
abrasive substances. Do not expose your device,
battery, or adapter to salt water or other conduc-
tive liquids. Do not expose your device, battery, or
adapter to pressurized water, high velocity water,
or extremely humid conditions (such as a steam
room). If your device, battery, or adapter gets wet,
carefully unplug all cables without getting your
hands wet and wait for it to dry completely before
plu~ging It in again. Do not attempt to dry your
device, battery, or adapter with an external heat
source, such as a microwave oven or a hair dryer.
To avoid risk of electric shock, do not touch your
device, battery, or adapter or any wires connected
to your device during a lightning storm while your
device, battery, or adapter is plugged in. If your
device, battery, or adapter appears to be damaged,
discontinue use immediately.
Users are required to use a power supply that com-
plies with PS2 or L.P.S. certification and approval.
Use only accessories supplied with your device,
or specifically marketed for use with your device,
to power your device. Use of third-party accesso-
ries may impact your device's performance. In
limited circumstances, use of third-party acces-
sories may void your device's limited warranty. In
addition, use of incompatible third party acces-
sories may cause damage to your device or the
third-party accessory. Read all safety instructions
for any accessories before using with your device.
Protect the device from direct sunlight. Install
the device at dry locations and protect It against
rain and humidity. The device may not get con-
tact to salt water or other conductive liquids. The
device must be charged only within a building in
a dry state.
Do not disassemble the device.
&
S AFEL Y CONNECTIN G YOUR RING VIDEO
DO O RBELL WIRED TO Y OUR HOME 'S
ELECTRI C AL WIRIN G
If you install the Ring Video Doorbell Wired where
a doorbell is already in use and you connect
the Ring Video Doorbell Wired to your home's
doorbell electrical wiring, you must turn off the
existing doorbell's power source at your home's
circuit breaker or fuse and test that the power is off
BEFORE removing the existing doorbell, installing
the Ring Video Doorbell Wired, or touching electri-
cal wires. Failure to turn off circuit breaker or fuse
so could result in FIRE, ELECTRIC SHOCK, or OTHER
INJURY or DAMAGE.
More than one disconnect switch may be required
to turn off the equipment before servicing.
To test whether you have successfully de-ener-
gized your existing doorbell's power source,
press your doorbell several times to confirm that
the power is off
If the electrical wiring in your home does not
resemble any of the diagrams or instructions
provided with Ring Video Doorbell Wired, if you
encounter damaged or unsafe wiring, or if you are
unsure or uncomfortable in performing this instal-
lation or handling electrical wiring, please consult
a qualified electrician in your area.
Only use accessories & power sources with L.P.S.
or PS2 certification that are recommended by
the manufacturer. Use of third-party accessories
may lead to damage to your Ring Video Doorbell
Wired or the accessory and may cause fire, elec-
tric shock, or injury.
Produ ct S pec ificati on s
De vic e N ame: Video Doorbell Wired
Mod el Nu mber: 5AT3T5
E le ctr ic al Ra ti ng : 10-24 VAC or 24VDC
Tempe ra t ur e Ra tin g: -5''F to 120"F (·20"C to 50°C)
RECY C LING YO UR DEVI CE PR O PERL Y
In some areas, the disposal of certain electronic
devices is regulated. Make sure you dispose
of, or recycle, your device in accordance with
your local laws and regulations. For information
about recycling your device, go to amazon.c om/
de vicesupport.
Term s of Servi ce and War ra nty
By purchasing or using the product, you agree to
the Terms of Service found at rin g .com /te rms .
For information on our warranty, theft protection,
and Ring Protect Plans, see ring. com /l egal.
For Consumers in the USA
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
NOTE : This equipment has been tested and
found to comply with the limits for a Class B dig-
ital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a res-
idential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be deter-
mined by turning the equipment off and on, the
user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
Increase the separation between
the equipment and receiver .
Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
Pursuant to Section 15.21 of the FCC rules, changes
or modifications to a Product by the user that are
not expressly approved by the pa~ responsible
for compliance could void the users authority to
operate the equipment.
The device meets the FCC Radio Frequency Emis-
sion Guidelines. Information on the product is on
file with the FCC and can be found by inputting
such Product's FCC ID (which can be found on the
device) into the FCC ID Search form available at
fcc. go v/oeV e a/ fc ci d.