Owner's Manual

Verify that the supply voltage is correct. Connect fixture to a 100 VAC~ 240 VAC 50/60
Hz power source. Properly ground fixture Always install wiring connections in accor-
dance with local code standards.
Produ ct Spe ci ficati ons
Dev i ce Name : Ring Floodlight Cam Wired Pro
Mode l Number : 5828S4
Elect ri ca l Rat i ng : Hardwired (100 to 240V)
Temperature Rating : -5°F to 118°F (·20.5°C to 48°C)
RE C YCLING YOUR DEVICE PROPERLY
In some areas, the disposal of certain electronic devices Is regulated. Make sure you
dispose of, or recycle, your device in accordance with your local laws and regulations.
For information about recycling your device, go to amazon .c om /devicesupport.
TERMS OF SERVICE AND WARRANTY
Use of the product is subject to your registration with Ring and your agreement with
the Terms of Service found at ri ng . com / terms .
To review your warranty coverage, please refer to the enclosure inside this box or visit
r ing .c om /warranty.
For Consumers in the USA
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-
ing t wo conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
NOTE : This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular installa-
tion. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Pursuant to Section 15.21 of the FCC rules, changes or modifications to a Product by
the user that are not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
The device meets the FCC Radio Frequency Emission Guidelines. Information on
the product is on file with the FCC and can be found by inputting such Product's
FCC ID (which can be found on the device) into the FCC ID Search form available at
fcc . gov / oe t/ e a/ f cci d.
The party responsible for FCC compliance is:
Ring LLC, 1523 26th St. Santa Monica, CA USA, 90404