Owner's Manual

Test yoL1r Panic Button}s Connection .
Now that you've picked a spot, you should test your
Panic Button's connection with the Base Station.
To do so, simply press the Setup button located on the
side of the device. Don't worry, the test will not set off
your Alarm.
When Base Station has detected the signal from Panic
Button, the LED will blink blue. If it blinks red, your Panic
Button cannot signal your Base Station. Try the Lest
again. You may find that repositioning the Panic Button
(even just a few inches) can improve reception.
8
If it still cannot connect, try installing
a Ring Range Extender between the
Panic Button and your Base Station .
--- Se tup button