Door View Cam
Charge the provided battery. Clean up any paint. First, fully charge the battery. Find it in the Door View Kit tray, along with the adapter and tightening nut. If your peephole was painted over, you may have to remove the excess in order to unscrew it (if not, skip ahead). = Charging = Charged Check for paint on or around your peephole, both indoors and outdoors. Plug it into a USB power source using the provided orange cable (located underneath your Door View Key).
Remove the outdoor half. Place the outdoor assembly. With the indoor side removed, the outdoor portion should slide right out. From the front side of your door, insert the tube through the hole until your Door View Cam is flush with the door. In the event that it doesn’t, check again for paint or other obstructions around the lens. Now it’s time to continue setup on the inside part of your door.
You might need the included adapter. Remove the rear cover. It’s used to support larger door view holes. Let’s find out if it’ll fit yours... Grasp the thin edge of the indoor assembly body, and pinch the cover at the indentations. Remove the adapter from the Door View Kit tray. From the indoor side of your door, place the adapter over the tube and cable, then slide it towards the hole. Pull the body and cover apart. Set the cover aside for now. If it DOES NOT slide in easily, don’t force it through.
Place the indoor assembly. Join the indoor and outdoor assemblies. Next, carefully slide the indoor assembly onto the tube until it’s flush with your door, making sure the outdoor assembly isn’t pushed out the other side. With the cable out of the way, place the tightening nut from the Door View Kit tray over the tube and into the hole. Once again, you may have to hold the outdoor assembly in place to keep it from falling out while placing the indoor assembly.
Plug in the connector. Insert the battery. Gently pull the cable taut, then firmly press the connector into the port on the indoor assembly, ensuring it is inserted. Slide the charged battery into the bottom of your Door View Cam until it clicks into place (don’t put the cover back on just yet). Complete setup in the Ring app. In the Ring app, select Set Up a Device and follow the in-app instructions. Once setup is complete, place the cover back on your Door View Cam. Secure the cable.
For additional help, visit: ring.com/help Or give us a call… US 1 800 656 1918 Canada 1 855 300 7289 Worldwide +1 310 929 7085 For a list of all our customer support numbers, visit: ring.com/callus To review your warranty coverage, please visit www.ring.com/warranty. © 2019 Ring LLC or its affiliates. Ring and all related logos are trademarks of Amazon.com, Inc. or its affiliates.
