Full Product Manual

1514
Motion Detector in a corner
Motion Detector on a wall
Motion Detector
Ring Alarm Motion Detectors are designed to detect
intruders by monitoring your spaces for changes
in heat and movement. By default, when armed in
Away mode, motion will set o the Alarm.
By adjusting Motion Detector settings in the app,
you can set the device to ignore your pets and only
detect humans, or to detect everything.
In Test Mode, motion is constantly detected, and
when motion stops, it will clear every few seconds.
Test Mode is designed to help you test for blind
spots, pets, and other environmental triggers.
Where should you place your Motion Detector?
• Install ' " above the floor, if possible.
• Install in a corner or on a flat wall
(see illustrations).
• Choose a location with a clear line of sight,
with no obstacles or blind spots.
To avoid false alarms:
• The Detector should not face a heat source such
as a stove, fireplace or windows with direct sun.
• Use the app to adjust motion sensitivity to
accommodate many pets.
• Make sure your pets can’t get close to the Motion
Detector by climbing on furniture.
• The Detector should be armed in Away Mode,
but disarmed in Home Mode. This is the
default setting.
Install steps:
. Connect
To connect your Motion Detector,
pull the battery tab.
. Configure
Using the app, decide where you will place
your Motion Detector; then give it a unique
name and assign it to a room.
. Install
If you’re mounting the Motion Detector on
a wall, peel the backing o the  pieces of
tape located on the back.
If mounting it in a corner, peel the backing
o the tape on each of the corners.