Installation Guide

Tools and supplies you may need

for installation

Required supplies:

• Ring Retroﬁt Alarm Kit, with the included #1 Phillips head screwdriver

• A screwdriver that ﬁts your existing wired alarm panel terminals

• A continuity tester or multimeter

Additional supplies you may need:

• A wire stripping tool

• Extra 20 or 22 gauge wire

• Twist on wire nuts or wire connectors

• Cleaning cloth or alcohol to clean the wall before using the included

mounting tape

• If you prefer to mount this device using screws, two screws and anchors to

mount the Retroﬁt Alarm Kit on the wall near your wired alarm panel,

plus a drill bit

• Masking tape and a pen, or some other method to label the wires

• If you plan to wire your Retroﬁt Alarm Kit through a hole in the metal alarm box,

make sure there is a rubber grommet around the hole to protect the wires

from damage. If it is missing, we recommend getting a replacement rubber

grommet at your local home improvement store.