USER GUIDE STORM 2 / 4 Please read this manual before operating STORM, and keep it for future reference.
Index 2 Introduction P03 Intellectual Property P03 Safety Introduction P04 Unpacking P05 Layout P06 Specification P07 Operation Instruction for STROM P08 Operation Instruction for SWING P09 Check list when troubling P10 Replacing lamp and flash tube P11 Accessories P13 Warranty P14
INTRODUCTION Thank you for your choice for STROM. STROM is designed for all photographers. It gives quicker and easier operation and great satisfaction for photographers. STROM is made of superior electric components in the world. ( Capacitor : Rubicon Company [only made in Japan], Flash Tube : Perkin Elmer Company [ Only made in Singapore]) Rime Lite telecommunications Web: www.rimelite.com Facebook: rimelites Twitter: @rimelites Mail : info@rimelite.
Safety Instructions Please read and understand all the instructions to avoid injury to yourself and/or damage to STROM - Do not expose to extream temperatuers ( above 140℉ or below -4℉, or above 60℃ or below -20℃). - Do not expose to moisture. Do not use STROM near water. - Do not let any foreign matter spill into STROM - Do not expose to chemicals such as benzene and thinners. Do not use liquid or aerosol cleaners. Clean with a soft damp cloth only.
Unpacking Your package contains the following items.
Layout 6 Number Description Number Description ① Protecting Glass ⑨ Main Inlet ② Modeling Lamp ⑩ Sync Socket ③ Flash Tube ⑪ Modeling Lamp Fuse ④ Modeling Base ⑫ Power Switch ⑤ Umbrella Holder ⑬ Modeling Power Intensity Up / Down ⑥ Locking Holder ⑭ Flash Power Intensity Up / Down ⑦ Photocell ⑧ FND
SPECIFICATION 7
Operation Instruction for STORM A. Insert a power cord into the main Inlet. B. Turn the power switch ON C. Before switching off, you better to set all buttons & indicators to “Minimum” or “OFF” How to set Flash Power Output - Turn the Flash encoder to change the setting. How to control Modeling Output 1. Continuous Modeling Mode - Press MODEL button - Modeling light keeps Full Volume Output regardless of flashing or charging. 2. OFF modeling Mode 3. - Press MOD button again.
Operation Instruction for SWING Before you use SWING with STORM, please power off strobes. You will experience the great performance of both strobe and SWING. Transmitter - Join the transmitter to a digital camera Receiver - Join the receiver to a strobe. Notice) when a user set the channel of SWING, the user should adjust the same number of both transmitter and receiver.
Check list when troubling 1. Cannot turn on the power. 1) Please check the power switch on. 2) Please check the power cable inserted correctly. 2. Unit does not flash. 1) Please check the flash tube inserted correctly. 2) Please check the trigger coil contacted with the flash tube legs. 3) Please change the flash tube. 3. Unit does not recharge. 1) Please check the power cable inserted correctly. 2) Please check the unit voltage supplies it correct. 3) Please change the fuse. 4. Ready “beep” does not sound.
Replacing lamp and flash tube You must switch off and disconnect the power cord before changing lamp or flash tube!! 11
Accessories 13
STORM is free of defects in material and workmanship for a period of twenty four (24) months from the original date of purchase by the consumer. If during the period of warranty this product proves defective under normal use and service, you should return the product to the retailer from whom it was originally purchased, or to any Rime Lite authorized dealer or authorized service center, if outside the time limit for returns imposed by the retailer. - Warranty Conditions 1.
