User guide

Rimage Autostar II and Protégé II
4 110629_F
Operate the Producer II
This section provides the information that you need to produce CDs or DVDs with the Producer II.
Powering on the Producer II
Before you begin:
The carousel must be installed before you power on the system. For more information about
installing the carousel, refer to
Installing the carousel on page 4.
1. To power on the Producer II, press the power
switch on the rear of the Producer II.
2. To power off the Producer II, press the power
switch.
Power Switch
Pausing the Producer II
You can pause the Producer II to add discs to the Producer II or change print ribbons.
1. To pause the Producer II, open the front door.
# Tip: The Active LED and the Carousel Present LED flash when the Producer II is
paused.
2. To resume operation, close the front door.
Installing the carousel
# Tip: To prevent errors, install the carousel before operating the software or powering on the
Producer II.
1. Open the front door.
2. Install the carousel in the Producer II.
a. Slide the carousel straight in so that the center post and top support bearing is in the
slot.
b. Lower the carousel and rotate it, if necessary, to seat the carousel securely.