User guide

Maintain the Producer II
PrismPlus! Printer
To align your PrismPlus printer, use the following instructions.
Required tools:
• T 25 Torx screwdriver
• 5/32” Allen wrench
1. Power on the Producer II.
 Note: If the PrismPlus power switch is in the on position, power on the both the printer
and the Producer by pressing the Producer II power switch.
2. Wait for the unit to complete the initialization.
3. Prepare the unit for alignment.
a. Manually move the lift arm to the top
of the Producer II.
b. To place a disc in the lift arm, press the
disc up into the lift arm while pressing
the disc release button.
c. To open the print tray, press the
printer button.
d. Close and re-open the door. This
releases the lift arm so you can
manually move it.
Lift
Arm
Gri
pp
e
r
Disc Release Button
4. Align the printer.
a. Slowly move the lift arm down until the disc just touches the print pad.
Printer
Button
Lift
Arm
Side to Side
Alignment
Print
Pad
Holding Pins
110629_F 9