User guide

Rimage Autostar II and Protégé II

8 110629_F

Printer

Button

Lift

Arm

Side to Side

Alignment

Pad

Holding

Pins

b. If the disc is not centered side to side on the print pad, align the printer side to side.

i. Loosen the side to side screws.

ii. Slide the printer, not the print tray,

until the side edges of the disc and

printer pad are aligned.

iii. Tighten the side to side screws.

Side to Side

Screws

Front to Back Screw

c. Using either the T25 Torx driver or the

5/32” Allen wrench, turn the front to

back alignment screw until there is a

1/16” (1.5mm) gap between the front

edge of the disc and the raised edge of

the disc retainer.

Disc

Retaine

5. Raise the lift arm out of the way of the print tray.

6. To close the print tray, press the printer button.

7. To release the disc from the gripper, press the disc release button.

# Tip: Place your hand under the disc to catch it.