User guide

Operator Button

The operator button is a push button that opens and closes the printer drawer and

runs diagnostics. The LED inside the operator button is on during transporter

operation. The LED also flashes during initialization, but is off when there are no

transporter operations.

Press the button once and the printer drawer opens. Press it again and the drawer

closes.

Press and hold the button for eight seconds and the transporter enters diagnostic

mode. For more detailed information, see “Button Diagnostics

” on page 23.

Warning Beeper

The Endeavor has a speaker that beeps to indicate a fault has occurred and that user

intervention is required. An empty supply bin or any autoloader or printer error

causes the speaker to beep. To stop the beeping, just open the supply door. Read the

error on the PC monitor or the LCD display, and fix the problem.

To change the number of beeps or to disable the speaker, refer to the Gemini Utilities

section (in the

# of Beeps on Fault dialog) on page 22 of this manual.

Lift Arm

The Lift Arm picks, transports, and releases discs. It has a Disc Present Sensor to

detect the supply bin, the recorder drawers, or when a disc is gripped on the lift arm.

At the underside of the lift arm are gripper fingers that hold the disc. Discs can be

manually pressed up onto the gripper fingers for alignment or other reasons. The disc

can also be removed by pulling the disc down and away from the lift arm.

 Lift Arm Gripper Fingers ! Disc Present Sensor

Disc Present Sensor

The Disc Present Sensor is depressed when a disc is secured on the gripper fingers.

It is also used to detect the supply bin and recorder drawers.

Door Sensor Switch

The door sensor switch detects if the door is opened or if the supply bin is missing.

If the supply bin is installed, it may not be seated firmly. Verify that the supply bin is

in place.